Single shaft shredder 2200R for RDF products is a general-purpose material shredder, which is widely used in the recycling industry, including the processing of waste furniture, wood, construction waste, plastic, rubber and other materials. To operate the Single shaft shredder 2200R for RDF products, you need to pay attention to the following steps.

1. Prepare materials

First of all, it is necessary to prepare the materials to be processed, and select the appropriate material size according to the size of the shredder outlet and the structure of the workbench to ensure the overall work efficiency.

2. Put the material into the feed port of Single shaft shredder 2200R for RDF products

Place the processed materials evenly on the feed port of Single shaft shredder 2200R for RDF products, and do not exceed the operating load of the machine.

3. Start Single shaft shredder 2200R for RDF products

Turn on the power, press the start button, and the Single shaft shredder 2200R for RDF products starts to work. During the operation, we should always pay attention to the working status of the machine to ensure the normal operation of the machine and the automatic shutdown protection of the fault.

4. Observe the shredding effect

After the material is processed by Single shaft shredder 2200R for RDF products, the required material crushing effect should be obtained. If necessary, multiple treatments can be performed to achieve a finer pulverization effect.

5. Close Single shaft shredder 2200R for RDF products

After finishing the work, press the stop button and disconnect the power to clean the machine.

It should be noted that the Single shaft shredder 2200R for RDF products should not be overloaded during use, and the pulley should be stopped for inspection when there is an abnormality in the pulley, so as to ensure that the produced materials are evenly crushed and make the work more efficient.