1. Too much feed, too fast
When the material is conveyed too fast and the Wood crusher supplier china feeds too much, the feeding amount of the feeder exceeds the load that the crusher can bear, causing blockage. In response to this situation, the feeding amount should be reduced, and the feeding method can be changed or controlled by increasing the feeder. If the blockage is serious, clear the material first, and then continue production. If the feeding speed is too fast, it will not only cause a large amount of crushed materials to accumulate in the silo, but also easily increase the production burden of the crusher equipment. In this case, the feed rate should be slowed down to remain stable and controllable. The feed rate can be adjusted by adjusting the excitation force or the eccentric angle of the feeder.

2. Improper discharge
If the discharge pipe is not smooth or the feed is blocked too fast, it will block Wood crusher supplier china; improper coordination between the discharge port and the conveying equipment will cause the discharge pipe to be blocked when the wind is weak or there is no wind. When the equipment failure is caused by the poor discharge of the crusher, it is necessary to clean the discharge port, replace the unmatched conveying equipment, and adjust the feeding amount to make the equipment operate normally.
The above is a brief introduction to the relevant knowledge about the solution to the blockage of Wood crusher supplier china.