Tel: 0086-543-4831130

COPYRIGHT ©  Shandong Hongxin Machinery Co., Ltd.   鲁ICP备16046072号       Poweredby:300.cn

HOME     ABOUT US     PRODUCT     NEWS    MESSAGES    CONTACT

E-mail:  snowsure@163.com

Tel:  0086 18863070778

ADD: Yuancheng, Changshan Town, Binzhou, Shandong, CHINA 

Home page
>
News
News
>
Industry news
What should be paid attention to during the operation of Log debarker?
$info.title

What should be paid attention to during the operation of Log debarker?
Release time：
10hours ago
Abstract:
Log debarker adopts the principle of rotating peeling, and uses the strength of the airflow of the high-power air compressor to peel the skin powerfully, and the peeling rate is higher and more professional. In the process of using Log debarker, the use of more professional technology and operations is more conducive to the yield of the product and the extension of the lifespan.
View details
Advantages of Log debarker?
$info.title

Advantages of Log debarker?
Release time：
2021-07-22 17:30
Abstract:
Log debarker can increase productivity with less wood damage.
View details
Log debarker's product knowledge introduction!
$info.title

Log debarker's product knowledge introduction!
Release time：
2021-07-15 16:01
Abstract:
Log debarker belongs to a series of wood processing machinery products.
View details
Customized vertical pellet mill small class explanation: preparation work before adjustment of pellet mill and experimental knowledge of air switch!
$info.title

Customized vertical pellet mill small class explanation: preparation work before adjustment of pellet mill and experimental knowledge of air switch!
Release time：
2021-07-09 15:42
Abstract:
Check whether the electricity, gas, and water in the production workshop are already in time and in a standby state.
View details
What are the reasons for the abnormal appearance of customized vertical pellet mill pellets and how to improve them?
$info.title

What are the reasons for the abnormal appearance of customized vertical pellet mill pellets and how to improve them?
Release time：
2021-07-02 11:18
Abstract:
The phenomenon that the pellets are bent with many cracks on one side is usually generated when the pellets leave the ring die. In production, when the cutter position is adjusted far from the surface of the ring die and the knife edge is blunt, the pellets are broken or torn by the cutter instead of being cut when they are extruded from the die hole. At this time, some pellets are bent. There are many cracks on one side and the other side. When this kind of granular material enters the cooler for cooling or transportation, it will often break from these cracks, resulting in too much granular powder produced.
View details
Page up
1
2
...
4